HPE Community
ProLiant Servers (ML,DL,SL)
1753835 Members
7907 Online
108806 Solutions
New Discussion

R3000 XR UPS with SNMP / Serial Card Configuration

 
Brian Hesseling
Occasional Contributor

‎07-15-2003 04:37 AM

‎07-15-2003 04:37 AM

R3000 XR UPS with SNMP / Serial Card Configuration

I have a R3000 XR with the SNMP/Serial Card but I cannot get the hyperterminal connection to come up when I try to make configuration changes to it. I have checked all of my settings and they are correct but all I get is a flashing cursor in hyperterminal. I need to get in to set up the IP address. Any help is appreciated. Thanks
0 Kudos
Reply
1 REPLY 1
Mark Spence
New Member

‎10-01-2003 09:53 AM

‎10-01-2003 09:53 AM

Re: R3000 XR UPS with SNMP / Serial Card Configuration

I just ran across your problem and I have sure you resolved by now.

The settings should just be 9600, 8, N, 1 and hit enter a couple of times to make the menu come up.

I have also seen where you may need to unplug the card and plug it back in to restart it. This can be done with the UPS on.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.