HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

RAID 1 rebuild stuck on 0%

 
alfred56
Occasional Visitor

RAID 1 rebuild stuck on 0%

Hi,

One of my clients has an old HP Proliant ML150 G6 1.0 with a B110i raid controller .

All weekend the server was down and this morning the office manager restarted the server and selected F1 to start a rebuild because there was some error about the raid-1 consistency.

Now when I access the Smart Array B110i SATA RAID Controller on System Board via HP System Management, it shows an exclamation mark on Logical Drive 1 - Mirroring (RAID 1) and states the following:

Percent Rebuild Complete: 0% and this percentage is not growing at all. Looks as if it is stuck there.

All the drives are OK with green check marks

My question is: Why does it need a rebuild if the drives show OK? I have not replaced any drives.

Have a look at the attached image.

Thanks and regards

Alfred56

Thanks and