HPE Community
ProLiant Servers (ML,DL,SL)
1754016 Members
7248 Online
108811 Solutions
New Discussion юеВ

Re: RAID 5

 
Ayman Altounji
Valued Contributor

тАО02-13-2001 04:00 PM

тАО02-13-2001 04:00 PM

RAID 5

When trying to configure raid 5 on an ML370 I am geting messages about the performance of auto reliability monitoring. Is this a hardware error or a problem with raid 5.

Thanks

Richard, U.K.
0 Kudos
Reply
2 REPLIES 2
Ayman Altounji
Valued Contributor

тАО02-14-2001 04:00 PM

тАО02-14-2001 04:00 PM

Re: RAID 5

Actually, neither. When the system is initially configured, the system does a background parity and reliability check (Dynamic Sector Repairing)--depending on the configuration it could take several hours. Until then, the performace accelerator will be disabled, but after that the system will be at fully capability.
0 Kudos
Reply
Ayman Altounji
Valued Contributor

тАО03-05-2001 04:00 PM

тАО03-05-2001 04:00 PM

Re: RAID 5

Background parity monitoring can take up to 24 hours after installation (depending on network load, etc).
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.