RAID SATA CTRL 82891GR over ML310 works bad

[superataru]

Hi all.
Today HP assistance changed my MB in my Proliant ML310 G3. They changed it because the older one reported that RAID 1 was degraded but Disks were ok and also Bios refused to accept the usual password we set!!!
Anyway . . . server was working fine with channel 0 sata disk, while the second was out (channel2).
Once the new motherboard was up, i went to enable embedded sata the to manage array.
With a big suprise CTRL SATA found raid informations over channel 2 disk and channel 0 was reported as "missing one".
Which is the problem? How car rebuild my array?
Tnx in advance.

[KarloChacon · Accepted solution]

hi


if you just want to rebuild you RAID



page 7, Rebuilding an array
http://www.jraf.ru/books/embedded_sata_raid_manual.pdf


also there is a SW to rebuild the Array

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=1119042&swItem=MTX-3f27718395524ff393ffc94d2d&prodNameId=3279693&swEnvOID=1005&swLang=8&taskId=135&mode=5

[superataru]

Hi. Tnx for the answer.
I red the manuals and installed hp software.
Well i've understood that my situations is not so simple, if it as a solution but . . . to reinstall Win203 Srv.
I got only one good disk (dynamic with 2003 srv), lost all RAID1 informations and, if i'm right, i cant do a build RAID1 on a new array because my onlu one disk in dynamic.
Isn'it? Tnx in advance.