No, you cannot mix HDD and SDD in a single array.
You may consider either add the SSD and clone the data or backup the data, swap all disks and restore your data.
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!
Hi
Yes, you cannot mix HDD (SAS/SATA) and SSD in a single array.
You can create new logical drive with SSD and clone the disk, or take restorable data backup from existing logical drive and restore the data backup on new logical drive create with SSD drives.
I am an HPE Employee
>> Yes, you cannot mix HDD (SAS/SATA) and SSD in a single array.
It is simply not possible.
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!