Replacing QLOGIC FC card

[adelgado]

Hi,

I have a DL380 G4 with two QLOGIC FC cards for connectivity to a StorageWorks 2/8q Fiber Channel Switch, for accessing the MSA 1000 Datastore.

The problem is that one of the QLOGIC FC card of Proliant server is faulty.

I've just bought one to replace, and phisically has been replaced.

But don't know how to do this new QLOGIC adapter being recognised by the StorageWorks 2/8q and the MSA1000.

When I open HP Array Configuration Utility, I still see the old QLOGIC card.

Thanks

[Torsten.]

If the Fc switch is configured for WWN zoning, you need to adjust it.

But first go into the ACU and check the SSP (selective storage presentation).

Is the new adapter listed there? Assign the approriate LUNs to this adapter.

[adelgado]

Hi,

The problem is that I don't see the new adaptet in SSP.

I've just pluged the network cable for one of the FC switches  to try to log on, but don't have the IP for managing.

Just I'm trying to get the information, but the previous Administrator didn't use to have documentation about.

Any ideas how to get it?

Thanks,

[Torsten.]

Consider to use the serial port, speed is 9600.

[adelgado]

Hi,

I've just got the IP and connected to the switch via Telnet.

How could I know if is configured for WWN zoning?

Thanks,

[Torsten.]

Try "zoneshow" via telnet.

Or go into zoneadmin:

[adelgado]

Hi,

I've typed "show config zoning", and this is the result:

Should I understant there is no zonning set?

Regards

[Torsten.]

Try to find a manual that meets your OS version:

http://h20565.www2.hp.com/portal/site/hpsc/template.PAGE/public/psi/manualsResults/?sp4ts.oid=315122&spf_p.tpst=psiContentResults&spf_p.prp_psiContentResults=wsrp-navigationalState%3Daction%253Dmanualslist%257Cviewall%253Dtrue%257Clang%253Den&javax.portlet.begCacheTok=com.vignette.cachetoken&javax.portlet.endCacheTok=com.vignette.cachetoken

I assumed the switch is a brocade, but I think it is a qlogic.

Try

zone list

zoneset list

zoning active

zoning list

[adelgado]

With "zone list" says is empty.

Still don't see replaced card.

Should I do any other steps?

Sorry to disturb you.

Thanks

[Torsten.]

Did you already boot the server?