ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

SCSI ID on 64-Bit Dual Channel Wide Ultra2 SCSI controller

Graeme May
Occasional Visitor

SCSI ID on 64-Bit Dual Channel Wide Ultra2 SCSI controller

I have a CL380 packaged cluster G1 and all documentation and forums refer to changing the SCSI id of the controller in each node to 6 and 7. When I use SCU from smartstart 5.5 under the 64 bit controller there is no option to change SCSI ID. Only Host Adapter number and controller order.
Can anyone tell me how to configure the SCSI ID for this controller please as I believe I am defaulting to 7 on each node and cannot get bot nodes up as a result.
Thanks
3 REPLIES
Doug de Werd
Honored Contributor

Re: SCSI ID on 64-Bit Dual Channel Wide Ultra2 SCSI controller

Check out page 2-2 and 2-3 in this document:

http://h200002.www2.hp.com/bc/docs/support/UCR/SupportManual/TPM_157839-004/TPM_157839-004.pdf

Thanks,
Doug
Expert in ProLiant Clusters
Doug de Werd
Honored Contributor

Re: SCSI ID on 64-Bit Dual Channel Wide Ultra2 SCSI controller

Also, have you checked the ROM version (should be P17, 4.10, 12/18/02) or later.

You might also try it with the first server powered off but with the storage on.

Doug
Expert in ProLiant Clusters
Graeme May
Occasional Visitor

Re: SCSI ID on 64-Bit Dual Channel Wide Ultra2 SCSI controller

Thanks for the reply doug. My problem is I simply dont have the option for SCSI ID under the f10 utilities or booting from SmartStart. I only can chnage Host Adapter Number and contoller order.

I am using P17 bios.

Graeme