HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

SCSI problem...

 
VernonLL
Occasional Visitor

SCSI problem...

We have ML110.

This message: This device has been validated to run at 80MB/s and should support 320 MB/s (**) when the operating system is loaded.

is appearing before. but now it doesn't and our scsi disk is running very slow even with the correct and latest drivers installed on win2k3. what could be the problem?
2 REPLIES
Brian_Murdoch
Honored Contributor

Re: SCSI problem...

Hi Vernon,

The message comes from the LSI logic controller BIOS according to this link but it doesn't explain why your disks are now running slower with the driver loaded.

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=418786&admit=-682735245+1172567617273+28353475

Brian

e4services
Honored Contributor

Re: SCSI problem...

I would say the drive is bad. Have you tried an appropiate drive test? Seatools, SCSIMax, IBM/Hitachi test software?
Hot Swap Hard Drives