SIM and blade enclosures

[Mark..Casemore]

We have a blade enclosure with a BL20 and a couple of BL25 blade servers. Physically, we have 6 blade servers, however, when viewing the enclosure through SIM, it only displays two.

[Oleg Koroz]

SIM release ?
Agents at Servers ?
Enclosure Firmware ?

[Mark..Casemore]

SIM release ?
Agents at Servers ?
Enclosure Firmware ?

SIM release = C.05.00.02.00
Agents = 7.51.0.0
Enclosure Firmware = 2.10

Thanks

[Oleg Koroz]

can you make 2.30 and run discovery or populate Manualy by name if discovery fails ?

[Albert Austin]

Hi,

See this link,

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1029392

Albert

[Mark..Casemore]

We had an engineer in on a seperate issue and he flashed the firmware to version 2.30. He also replaced 3 modules on the back of the enclosure (backplanes, can't remember which ones. With all this, still only 2 servers appear. I will try the link next.

Thanks.

[Rajashekar Chintakunta]

Hi Mark,

Try the follwoing and check if this helps:

1) Goto ILO SNMP Settings and assign the IP address of the HP SIM server and the host Server for all Blade ilos.

2) Open the SNMP service properties and in the Traps tab specify the IP address of the HP SIM Server.

Hope this helps.

[Oleg Koroz]

check resolution steps, it might help

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c00709390&jumpid=reg_R1002_USEN

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c00712058

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=PSD_ES041118_CW01