ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

SIM and blade enclosures

Mark..Casemore
Occasional Advisor

SIM and blade enclosures

We have a blade enclosure with a BL20 and a couple of BL25 blade servers. Physically, we have 6 blade servers, however, when viewing the enclosure through SIM, it only displays two.
7 REPLIES
Oleg Koroz
Honored Contributor

Re: SIM and blade enclosures

SIM release ?
Agents at Servers ?
Enclosure Firmware ?

Mark..Casemore
Occasional Advisor

Re: SIM and blade enclosures

SIM release ?
Agents at Servers ?
Enclosure Firmware ?

SIM release = C.05.00.02.00
Agents = 7.51.0.0
Enclosure Firmware = 2.10

Thanks
Oleg Koroz
Honored Contributor

Re: SIM and blade enclosures

can you make 2.30 and run discovery or populate Manualy by name if discovery fails ?
Albert Austin
Esteemed Contributor

Re: SIM and blade enclosures

Mark..Casemore
Occasional Advisor

Re: SIM and blade enclosures

We had an engineer in on a seperate issue and he flashed the firmware to version 2.30. He also replaced 3 modules on the back of the enclosure (backplanes, can't remember which ones. With all this, still only 2 servers appear. I will try the link next.

Thanks.
Rajashekar Chintakunta
Honored Contributor

Re: SIM and blade enclosures

Hi Mark,

Try the follwoing and check if this helps:

1) Goto ILO SNMP Settings and assign the IP address of the HP SIM server and the host Server for all Blade ilos.

2) Open the SNMP service properties and in the Traps tab specify the IP address of the HP SIM Server.

Hope this helps.