- Community Home
- >
- Servers and Operating Systems
- >
- ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- SMART ARRAY P400 / PROLIANT DL 380 G5
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
06-12-2017 07:09 AM
06-12-2017 07:09 AM
SMART ARRAY P400 / PROLIANT DL 380 G5
Good morning , could you support to me in the following issue ? we have DL 380 G5 installed and we have RAID1 ,using smart array P400 card , each time when we try to rebuild the second disk to establish the RAID1 array , it has passed all the step I mean rebuilding , Ok , but after that it changes to predictive failure according to event diagnostic event id 1216 , I have investigated about it , and it could be because some issues related to hard drive drive could have been reached , sectors issues and pending counts enable the flag and it showes the message predictivable failure , we have tried with another disk but it has happened the same , the fix could be to get a new disk same size and functionality of located at bay 0 and put in bay 1 and if it continues could exchange the first one also by a new one and configure a RAID 1 again , and do a restore of tje information , Is it posible ?
Also Is there any problem if we can move the disks from bay 1 , 2 to bay 3 ,4 and to try again , If we change the disks from bay 1 , 2 to bay 3, 4 I s there any problem with the functionality of the RAID , I mean in the step when we installed the second disk I mean , shutdown the server , change the disk 1 to bay 3 , boot server , then put the second disk into bay 4 and try to rebuild the RAID1 , it could be done without any lost of data , Is it correct ?
Thanks for your support
Best Regards
Ricardo M
Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP