ProLiant Servers (ML,DL,SL)
1745911 Members
4107 Online
108723 Solutions
New Discussion

SNMP and temperature data in Windows 2012 R2

 
loginName0000
Occasional Visitor

SNMP and temperature data in Windows 2012 R2

Prior to upgrading our Proliant Gen8 server to Windows 2012 R2, I was able to get the temperatures of the system via SNMP by querying the IP address of the server (10.0.0.2).  After the install for Windows 2012 I get an error message "noSuchName at ObjectName(1.3.6.1.4.1.232.6.2.6.8.1.4.0.1)"

So I reinstalled HPE Insight Management Agent, HP Agentless Management Service and HPE WBEM Insight but still can't query temperature via SNMP.  However, if I go query the iLO IP (192.168.0.222) I can get successfully query MIB 1.3.6.1.4.1.232.6.2.6.8.1.4.0.1.

Question: what component or setup I missing on Windows Server 2012 so I can query via SNMP the temperature readings from iLO interface using the server ip address (10.0.0.2)? I recall I had to fiddle with some setting when I first got this working prior to upgrading but I can't figure it out.

1 REPLY 1
loginName0000
Occasional Visitor

Re: SNMP and temperature data in Windows 2012 R2

I figured out the issue.  Instead of querying "1.3.6.1.4.1.232.6.2.6.8.1.4.0.1" on localhost, I should be querying "1.3.6.1.4.1.232.6.2.6.8.1.4.1.1" I'm not sure why MIB are different after upgrading operating system but now I can query the HOST instead of ILO port like I had before.

I found the correct mib by using Mibble.