ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

SNMP info for physical drives on a DL360 G6 running Windows 2012 r2

SOLVED
Go to solution
jboettger
Occasional Contributor

SNMP info for physical drives on a DL360 G6 running Windows 2012 r2

I am running Windows 2012 r2 on a DL 360 G6.  I am trying to get physical disk info from the plugged in hard drives but I am unable to attached.  I am using PRTG.  When I try to install a probe for SNMP HP Physical Disk it says no disks exist.  When I walk the host with an snmp tester no physical disk info is logged in the output.  I have the management agents installed and the WBEM agents installed as I can see the stuff in the HP Management page but I cannot get PRTG to see the physical drive info.  it does see the fan info, cpu info, overall status info.   I have a similary configured DL360 G6 running Win 2008 r2 and have no problems seeing physical disk info.  i also try setting up ILO port and can see general info but no physical disk info.

Any insight would be greatly appreciated.

Thanks

Jim

2 REPLIES
Torsten.
Acclaimed Contributor

Re: SNMP info for physical drives on a DL360 G6 running Windows 2012 r2

Identical disk controllers in use? With identical firmware versions?


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
jboettger
Occasional Contributor
Solution

Re: SNMP info for physical drives on a DL360 G6 running Windows 2012 r2

An outdated 410i array controller driver was the culprit.

All set now.

Thanks

Jim