HPE Community
ProLiant Servers (ML,DL,SL)
1751710 Members
5048 Online
108781 Solutions
New Discussion юеВ

Server crash on boot after bonding eth

 
Arakattack_1
Advisor

тАО12-28-2007 11:08 PM

тАО12-28-2007 11:08 PM

Server crash on boot after bonding eth

Hello,

I have searched entire forum but didn't find result similar with my problem.

I installed RHEL on Proliant DL380, I set up bonding channel for 2 built-in gigabyte ethernet with load balancing mode. It working good until i install PSP (Proliant Software Pack), my server would not boot if both network cable connected to switch.

But it will be ok if i detach 1 cable and connected it after server fully loaded.

Please help me to figure-out this problem. thanks
0 Kudos
Reply
2 REPLIES 2
Univer_1
Valued Contributor

тАО12-29-2007 01:59 AM

тАО12-29-2007 01:59 AM

Re: Server crash on boot after bonding eth

Try to uninstall PSP. It seems that the PSP make change to your eth configuration at /etc folder.
0 Kudos
Reply
Arakattack_1
Advisor

тАО12-29-2007 02:14 AM

тАО12-29-2007 02:14 AM

Re: Server crash on boot after bonding eth

Do you think this is best idea?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.