ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Step by step configuration in RAID 0 and RAID 1

 
jhunnez
Occasional Visitor

Step by step configuration in RAID 0 and RAID 1

Im newbie in RAID, i have Windows Server 2003 R2 Standard Edition and i want to mirror my first drive(system). My server is HP Proliant ML110 G5, When i enable the RAID controller in BIOS i got blue screen error and restart my unit. Can you help me to configure my server to use RAID controller.Thanks in advance.
2 REPLIES
TTr
Honored Contributor

Re: Step by step configuration in RAID 0 and RAID 1

Normally you configure the raid controller before you install the OS. Now when you enable the controller, it hides the physical disk from the server that's why you can not boot.

You may be able to do it after the fact based on the user guide on page 6
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00474317/c00474317.p
df?jumpid=reg_R1002_USEN

Also look in this thread http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=1209664

at the reply with the 7 steps dated Mar 4, 2008 21:10:18 GMT

Take a good backup of the system in case something goes wrong.
ab_server
Frequent Advisor

Re: Step by step configuration in RAID 0 and RAID 1

First, I would like to know what type of controller do you have for your ML100 Series ? (this is since there are some Proliant 100 Server Series that do not contain controllers, i.e. the G2 version)