HPE Community
ProLiant Servers (ML,DL,SL)
1752799 Members
6216 Online
108789 Solutions
New Discussion юеВ

Re: Support Pack 7.51 on ML 530 G1 - not working

 
Jon White
Regular Advisor

тАО07-31-2006 12:55 PM

тАО07-31-2006 12:55 PM

Support Pack 7.51 on ML 530 G1 - not working


I have a ML530 G1 that I am attempting to run the Support Pack 7.51 on it. It Extracts fine. However, when the program is run, it does not display the devices installed or the driver versions.

If it has any bearing on this, the 7.50 firmware CD ran fine on this and updated the system bios. It did not update any other devices.
No matter where you go, there you are....
0 Kudos
Reply
2 REPLIES 2
Jaime Bolanos Rojas.
Honored Contributor

тАО08-01-2006 12:07 AM

тАО08-01-2006 12:07 AM

Re: Support Pack 7.51 on ML 530 G1 - not working

Jon,

Did you configured your SNMP protocol fine, configure the system management homepage, remember that those features need to be configure for all those item to display on the system.

Regards,

jaime.
Work hard when the need comes out.
0 Kudos
Reply
Oleg Koroz
Honored Contributor

тАО08-01-2006 12:49 AM

тАО08-01-2006 12:49 AM

Re: Support Pack 7.51 on ML 530 G1 - not working

Worst scenario run manually
Most important:

System driver
scsi ...
nic ...
agents

ACU utility
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.