ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

System Overheating (Temperature Sensor 8)

najibbasalamah
Occasional Visitor

System Overheating (Temperature Sensor 8)

Sorry if my english not good enough

I'm a newbie in server maintenance and troubleshoot. I have some problems here. My server is ProLiant DL360p Gen8. My server always rebooting. When I check Integrated Management Log, I found some critical isuue, such as :

 

1. Critical Temperature Threshold Exceeded

2. System Power Fault Detected. System Has Enabled Power Protection and Disabled Power Supplies (XR: 00 00 MID: FF 0D FE 06 FF FF 2A 2A 0C 0C 00 01 00 00 03 01 82 00 00 00 00 40 00 00 00 00 00 00 00 00 00 00), 

3. System Overheating (Temperature Sensor 8, Location Memory, Temperature 80C)

 

Is there any solutions to fix this problem? Thanks

1 REPLY

Re: System Overheating (Temperature Sensor 8)

Hello,

Check room temperature and if something is blocking airflow ( front / rear server ).
Please Update the Server with latest BIOS & ILO firmware using the Lastest SPP

if problem persist, contact local hpe, because memory or mainboard may need to replace.

Kind Regards,
Erdogan.
I am HPE Employee

If this helps you with your issue, please click the thumb to register a Kudo.
If it resolves the issue, please consider marking it as an Accepted Solution.
The comments in this post are my own and do not represent an official reply from the company. No warranty or guarantees of any kind are expressed in my reply.