ProLiant Servers (ML,DL,SL)
1753797
Members
7111
Online
108799
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2006 10:31 AM
02-14-2006 10:31 AM
T1000 XR
Hi,
I have a Proliant ML 370 G4 connected to a T1000 XR UPS and I find that everytime the power goes out and it returns after a while, the UPS goes to Standby mode and not to Operate mode. I've tried to configure the HP RPM 1.1 to turn the UPS but I'm not sure which settings should be configured. Especially as there is no power going to the server after the UPS goes to Standby mode. The UPS is connected to the server via a serial cable on COM1 and it can be detected by the RPM when it is up and running.
Thanks
I have a Proliant ML 370 G4 connected to a T1000 XR UPS and I find that everytime the power goes out and it returns after a while, the UPS goes to Standby mode and not to Operate mode. I've tried to configure the HP RPM 1.1 to turn the UPS but I'm not sure which settings should be configured. Especially as there is no power going to the server after the UPS goes to Standby mode. The UPS is connected to the server via a serial cable on COM1 and it can be detected by the RPM when it is up and running.
Thanks
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP