- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Re: Team TX Heartbeat
ProLiant Servers (ML,DL,SL)
1748024
Members
4230
Online
108757
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2006 07:10 PM
05-21-2006 07:10 PM
Team TX Heartbeat
One of 2 NC7770 shows as status Failed ( Tx Heartbeat).
Is that Network failure ?
I saw that after HP 7.40 update
Is that Network failure ?
I saw that after HP 7.40 update
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-23-2006 02:27 AM
05-23-2006 02:27 AM
Re: Team TX Heartbeat
That error message means that the NIC was not able to transmit a frame (heartbeat frame) onto the wire.
This can be caused by unplugging link while the NIC is trying to transmit the heartbeat frame or it can be caused by a bad NIC. The transmit heartbeat test is there to test the transmit capabilities of the NIC.
If the error condition persists (it happened more than a couple of times), I recommend swapping cables between the two NICs to see if the problem follows the cable or follows the NIC. If it follows the cable, replace the cable. If it follows the NIC and the NIC is under warranty, have the NIC replaced.
Best regards,
-sean
This can be caused by unplugging link while the NIC is trying to transmit the heartbeat frame or it can be caused by a bad NIC. The transmit heartbeat test is there to test the transmit capabilities of the NIC.
If the error condition persists (it happened more than a couple of times), I recommend swapping cables between the two NICs to see if the problem follows the cable or follows the NIC. If it follows the cable, replace the cable. If it follows the NIC and the NIC is under warranty, have the NIC replaced.
Best regards,
-sean
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP