HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

The problem when I install the driver of NC110T for SUSE LINUX on HP DL380 G5

 
lixiaofeng
Occasional Visitor

The problem when I install the driver of NC110T for SUSE LINUX on HP DL380 G5

I had downloaded the driver and installtaion guide from HP support site;
Driver name is e1000-7.6.9.1-1.src.rpm;
The guide told that in step "Kernel Source Code Setup" we need execute:
# cd /usr/src/linux-
# make mrproper
# make cloneconfig
# make dep
But I met such problem:
IUAS-1:/usr/src # cd linux-2.6.5-7.244
IUAS-1:/usr/src/linux-2.6.5-7.244 # make mrproper
make: *** No rule to make target `mrproper'. Stop.
IUAS-1:/usr/src/linux-2.6.5-7.244 #
IUAS-1:/usr/src/linux-2.6.5-7.244 # uname -r
2.6.5-7.244-bigsmp

Please the HP specialist provide me the sovled method! Thanks
1 REPLY

Re: The problem when I install the driver of NC110T for SUSE LINUX on HP DL380 G5

the headers package installed but not the sources package. Once that's installed the make mrproper target should work
mrproper is used to "clean" the kernel-source tree from previously compiled files, so you can start fresh - even without a old .config.
However - you need the kernel-source installed for this and run this command from /usr/src/linux (or /usr/src/linux_version_)
whats in the /usr/src/linux ?