HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Ultra320 SCSI Card install problem

 
Bob Coulton_1
Occasional Visitor

Ultra320 SCSI Card install problem

After I installed the card my DL360 G2 Server won't boot up, it stops after it recognizes the onbard array controller, so I'm thinking that's what is causing the problem.

Any help would be appreciated.
Thanks!
2 REPLIES
NMory
Respected Contributor

Re: Ultra320 SCSI Card install problem

Could be a compatibility problem with you server. Check the quickspecs of the server under Storage Controllers to see if you have the supported SCSI card:

http://h18004.www1.hp.com/products/quickspecs/11049_na/11049_na.html

Also, if you were using another SCSI card to boot the server, then, you should boot with the previous one (take the new one out), install the drivers for the new one, shutdown, install the new one, and reboot the server.

Regards,

LN
Terry Hutchings
Honored Contributor

Re: Ultra320 SCSI Card install problem

Does the ILO initialize normally? I believe it should show up right after the 5i in that server.
The truth is out there, but I forgot the URL..