- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Unable to write to D:\$Mft
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2011 11:02 PM
07-19-2011 11:02 PM
Unable to write to D:\$Mft
Hi All,
I have a HP ProLiant ML150 G5 with 2x500Gb disks configured as a 1Tb logical volume, running WIndows Server 2003
I have 68Gb in the system C: drive and 983 Gb in the D: drive, Oracle is on the D: drive.
The server has been running well over 2 years with no issues.
When I started upgrading Oracle 10.2.0.1 to Oracle10.2.0.3 I rebooted as advised. in the middle of the process.
Now when starting the E200 Intelligent COntroller gives a message about "A new disk drive has been added or a previously failed disk drive has returned to service, F1 toadd the new drive orF2 to accept the data loss and use teh previous configuration.. When I use F2 I can see the D: drive but I get continual errors about unabel to write , Delayed Write to D:$Mft, Windows does not recognise any Oracle binaries on the D: drive.
Should I reformat the D: drive,rebuild the logical drive or continue to seek a software solution?