- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Upgrading Smart 2/E to Smart 2SL problem
ProLiant Servers (ML,DL,SL)
1752806
Members
5664
Online
108789
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-06-2002 04:00 PM
09-06-2002 04:00 PM
Upgrading Smart 2/E to Smart 2SL problem
I am currently running Windows 2000sp3 on a Raid-5 array connected to a Smart 2/E EISA card in EISA/PCI slot. I want to move the array to a 2SL in the PCI slot but after switching all of the hardware, reconfiguring everything in the EISA config, making sure that the new card is running current bios level (4.50A)... I can boot to the Service Console just fine and run CHKDSK with no problems. But... if I try to boot Windows, I get a blue screen saying "inaccessible boot device"...
Infact, if I just move the 2/E card to a different EISA slot, I get "inaccessible boot device" as well.
Any ideas?
Thanks!
Infact, if I just move the 2/E card to a different EISA slot, I get "inaccessible boot device" as well.
Any ideas?
Thanks!
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-10-2002 04:00 PM
09-10-2002 04:00 PM
Re: Upgrading Smart 2/E to Smart 2SL problem
Hello,
Please make sure that your boot controller order is set to first. You can also clear NVRAM and run system configuration.
Regards,
Please make sure that your boot controller order is set to first. You can also clear NVRAM and run system configuration.
Regards,
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP