HPE Community
ProLiant Servers (ML,DL,SL)
1752290 Members
4935 Online
108786 Solutions
New Discussion

Want three physical drives configured as raid 0...no raid

 
GaryFuqua
Occasional Contributor

‎12-13-2014 02:30 PM - edited ‎12-13-2014 02:42 PM

‎12-13-2014 02:30 PM - edited ‎12-13-2014 02:42 PM

Want three physical drives configured as raid 0...no raid

I have a Prolient ML350P Gen 8.    I want to configure the three physical hard drives to be three separate drives.    I can't figure it out.   Smart Storage Administrator only allows me to create 2 array with one drive each.  Then I am stuck with one unassigned drive.     Cannot create more than three arrays.

 

There has got to be a way to make this most simple configuration...one drive = 1 logical drive, beyond two physical drives.

 

Help!?

 

 

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎12-15-2014 04:01 AM

‎12-15-2014 04:01 AM

Re: Want three physical drives configured as raid 0...no raid

Do you use the embedded P420i?

Is there a cache module installed?

The entry model has none.

 

From quickspec:

 

Logical Drives Supported
Zero Memory, Up to 2 logical volumes (8 physical drives)
Up to 64 logical drives with cache
 

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.