ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Weak lithium battery in ProLiant 800 II 350

Edward Zamyslowski
Occasional Contributor

Weak lithium battery in ProLiant 800 II 350

My ProLiant 800 II 350 has probably weak 3V lithium battery because it lose configuration every time it is switched off for a few hours.
A baterry looks to be soldered to the mainboard.
Where can i obtain a new one?
3 REPLIES
Oleg Koroz
Honored Contributor

Re: Weak lithium battery in ProLiant 800 II 350

I belive there is two ways:
unsolder the old one, so buy any round battery at Radio Shack 3v (3.3v) and solder same way + to +, - to -. They might sell plastic battery casing, which can be mounted at system board.

If I'm not Wrong there should be Jumper set beside battery, something like 4-to 6 pins, with legend, two pins on the edge Jumper for Internal battery, see if others allow you to connect additional battery (no soldering needed).
Sean Marshall_1
Frequent Advisor

Re: Weak lithium battery in ProLiant 800 II 350

the part you need is spare part number 160274-001. You Should not remove the old battery at all. This can cuse the server to not function properly. Check page 22 in the user guide - (section 2-22) http://h200001.www2.hp.com/bc/docs/support/UCR/SupportManual/TPM_186861-01_ch2/TPM_186861-001_ch2.pdf

You can order the part from 1-800-227-8164 if you are in the States.

Sean Marshall_1
Frequent Advisor

Re: Weak lithium battery in ProLiant 800 II 350