Witch FCAL port is it ??? (Blade system p-Class)

[Benoit TOURRET_1]

Hello,

I am trying to connect a fc cable to a blade system.

there is no FCAL switch, just two "RJ-45 Patch Panel" with on front 8 places for SFF Tranceivers and 16 lan ports at the rear.

I put the BL20p G3 with its FC adapter in slot2 of the blade enclosure.

where should I plug the two SFF Tranceiver ???
the card is detected by W2k3, but there is no led or anything else.
whereever i plug the tranceiver, the xmit laser lits, even if there is no FC adapter.

I didn't found any Map or drawing fot that parch panel.

Thanks,

Benoit.

[Benoit TOURRET_1]

The FC port of the blade bl20 on slot 1 is the lowest on the "RJ-45 patch Panel 2", the highest is for the slot 8.

HTH,
Benoit.