HPE Community
ProLiant Servers (ML,DL,SL)
1754014 Members
7649 Online
108811 Solutions
New Discussion

Witch firmware needed for SSD 2.20 drivers

 
Ayman Altounji
Valued Contributor

‎03-07-2001 04:00 PM

‎03-07-2001 04:00 PM

Witch firmware needed for SSD 2.20 drivers

When I install SSD 2.20 do I need a minimum of firmware level on e.g. array controllers, or can I just install the latest drivers without any problems.
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎03-14-2001 04:00 PM

‎03-14-2001 04:00 PM

Re: Witch firmware needed for SSD 2.20 drivers

I recommend using the latest you can get. Also, run the latest System Configuration Utility and make sure the correct SCSI controller is set for primary after the firmware update. Then remember to SAVE and exit (don't just abandon the setup).

Proliant 2500 ROMPaq

System Configuration Utility
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.