ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

a proplem with DL360 G4

Believe_2
Occasional Advisor

a proplem with DL360 G4

Hi all
can you help me with my server DL360 G4 pls.
My server: Xeon 2.2, ram 2GB but it's boot very slow, it's about 15 minutes. I don't have to receive a error note. I have ran Dianogstic and everything is OK.
My HDD is SAS HDD with Raid 1. But i think it's unrelated because i try convert it to raid 0. My server is still slow.
I don't know why. Help me soon pls!
10 REPLIES
KarloChacon
Honored Contributor

Re: a proplem with DL360 G4

hi

I suppose you mean windows is very slow to load
after the server POST? am I right?

do you have any attached device to the server? storage?

do you have latest PSP or firmware?

regards
Didn't your momma teach you to say thanks!
KarloChacon
Honored Contributor

Re: a proplem with DL360 G4

hi

I suppose you mean windows is very slow to load
after the server POST? am I right?

do you have any attached device to the server? storage?

do you have latest PSP or firmware?


same issue?

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1175856


regards
Didn't your momma teach you to say thanks!
Believe_2
Occasional Advisor

Re: a proplem with DL360 G4

Hi
not really. My server boot slow when the raid system appear:

...Smart array 6i controller ....


???
Víctor Cespón
Honored Contributor

Re: a proplem with DL360 G4

DL360 G4 with Smart Array 6i and 2 SAS disks? Where? Smart Array 6i is SCSI (parallel), not SAS. The delay is after the Smart Array message, while it detects the disks? Try reseating the disks and disk backplane.
Believe_2
Occasional Advisor

Re: a proplem with DL360 G4

I don't thinh so, because it's slow when my HDD is detected. After Smart Array 6i controller appear.
any reasons ?
KarloChacon
Honored Contributor

Re: a proplem with DL360 G4

yes Believe vcespon's idea is a good one (don't say that)

try vcespon steps, reseat SCSI-SAS backplane, reseat HDDS.

also clear NVRAM (do you know the procedure?)

also try updating firmware for the controller

and boot server without HDDs and check if takes too long again when the controller appears in POST

regards

Didn't your momma teach you to say thanks!
KarloChacon
Honored Contributor

Re: a proplem with DL360 G4

mmm something else

reseat PCI riser cage OK

regards
Didn't your momma teach you to say thanks!
Believe_2
Occasional Advisor

Re: a proplem with DL360 G4

THank all, but i must instead the mainboard so my server run quickly.
maybe the mainboard has some errors
KarloChacon
Honored Contributor

Re: a proplem with DL360 G4

hi

server is running fine?

if so what did you do?

regards
Didn't your momma teach you to say thanks!
Believe_2
Occasional Advisor

Re: a proplem with DL360 G4

Yes, i't running fine now.
Because I had replaced a new mainboard for my server.