ProLiant Servers (ML,DL,SL)
1748104 Members
4553 Online
108758 Solutions
New Discussion юеВ

Re: array not reading drives

 
SOLVED
Go to solution
donkarnash_1
Frequent Advisor

array not reading drives

Hello, I have a Proliant ML570 G3 server and it has two raid controllers. When I plug a 300GD hard drives to the slots on the bottom right and click on ACU, I cannot see those drives and the drives has no lights. Attached is the doc with screenshots for better explanation. can anyone please advise. Thanks
2 REPLIES 2
KarloChacon
Honored Contributor
Solution

Re: array not reading drives

hi donkarnash

you must check your cabling the one the goes from controller to your SCSI backplane I mean there must a cable from controller to HDDs located at the right bottom

check attached picture

regards
Didn't your momma teach you to say thanks!
James ~ Happy Dude
Honored Contributor

Re: array not reading drives

Hello,
I am sure you might have tried this; but again, after checking the cabling, have you tried "RESCAN CONTROLLERS" ??

Firmware for the controller ?

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=408482&swItem=MTX-449826b3240c48bd881384f3bf&prodNameId=3285473&swEnvOID=1005&swLang=8&taskId=135&mode=4&idx=3

Regards,