HPE Community
ProLiant Servers (ML,DL,SL)
1752810 Members
5839 Online
108789 Solutions
New Discussion

bypassing 'Press "F1" key to continue'

 
don kee
New Member

‎06-07-2003 06:47 AM

‎06-07-2003 06:47 AM

bypassing 'Press "F1" key to continue'


Hello. My ProLiant 1600 stops immediately after hardware initialization and prompts me to:

Press "F1" key to continue
"F10" key for System Partition Utilities

How can I bypass this? If this server is rebooted remotely it would hang here and I don't intend to keep a keyboard/monitor attached to it.
0 Kudos
Reply
1 REPLY 1
Sunil Jerath
Honored Contributor

‎06-07-2003 09:35 AM

‎06-07-2003 09:35 AM

Re: bypassing 'Press "F1" key to continue'

Hello Don,
Please disable F1 in the BIOS which can be done by pressing F10 and hold down the Ctrl Key and hit 'A' which will enable Advanced Mode. About 1/3rd down you will see the F1 key. This is where you can enable or disable it.

Regards,
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.