Another way - using the latest drivers
Manual install of Netware 4.11 on a Compaq
ML370 with Smart Array 5300 controller.
make directory on DOS partition MKDIR C:\NWUPDATE
In the following steps, if you are asked to confirm overwrites,
answer 'yes' or 'yes to all.'
Insert the SmartStart and Support Software CD-ROM into your CD-ROM drive (E:)
Copy E:\CPQSUPSW\NSSD\NETWORK\*.* C:\NWUPDATE\*.*
Copy E:\CPQSUPSW\NSSD\IDE\3X_4X\*.* C:\NWUPDATE\*.*
Copy E:\CPQSUPSW\NSSD\NWPA\*.* C:\NWUPDATE\*.*
Copy E:\CPQSUPSW\NSSD\NWPA\4X\*.* C:\NWUPDATE\*.*
Del C:\NWUPDATE\SCSIHD.*
Insert the NetWare 4.11 Operating System CD.
Type E:\INSTALL
After the hardware detection finishes, we don't want the
automatically detected drivers, so
a) At the Driver Summary screen, press
to reach the server console.
b) At the server console, type ?load C:\NWUPDATE\NWPA.NLM?.
c) At the server console, type ?load C:\NWUPDATE\CPQSHD.CDM?.
d) At the server console, press to return to Driver Summary screen.
e) At the Driver Summary screen, choose Select additional or modify selected Disk/LAN drivers.
f) Highlight Disk and CD-ROM Drivers and press .
g) Choose Deselect a selected driver to remove ALL pre-selected drivers.
h) Choose Select an additional driver and press .
i) Press at the Disk Driver list.
j) Press to specify a different path.
k) Type ?C:\NWUPDATE? and press .
l) Select the appropriate drivers for your Compaq hardware. For disk and array drivers, you do not have to enter any parameters (i.e., slot number)For the Smart Array 5300 I chose CPQRAID
m) Answer Yes to the Load Additional Drivers question and select any remaining drivers as required for your hardware.
n) Select Continue Installation.
o) At the Driver Summary screen, choose Select additional or modify selected Disk/LAN drivers
p) Highlight Network (LAN) Drivers and press .
q) Choose Deselect a selected driver to remove ALL pre-selected drivers.
r) Choose Select an additional driver and press .
s) Press at the LAN Driver list.
Press to specify a different path.
u) Type ?C:\NWUPDATE? and press .
v) Select the appropriate drivers for your Compaq hardware. Answer No to Save existing driver questions. You will have to enter a slot number for your network card.
w) Answer Yes to load any remaining network drivers as required by your hardware.
x) Select Continue Installation.
When the server is setup delete the directory C:\NWUPDATE to avoid confusion.
