HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

configure DB array as SB array

 
SOLVED
Go to solution

configure DB array as SB array

Is possible to configure a Dual bus storage array as a single bus array?
I have a 302970-b21 db storage array and I want to configure with only one scsi cable.
3 REPLIES
Torsten.
Acclaimed Contributor
Solution

Re: configure DB array as SB array

I think this was already solved in your other thread:

http://forums12.itrc.hp.com/service/forums/questionanswer.do?threadId=1239685

The difference between the SB and DB model is the I/O module.

If you connect only 1 cable to the DB module, you have only the left *OR* right half connected.

Replace the DB with a SB module to get the SB model.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Torsten.
Acclaimed Contributor

Re: configure DB array as SB array

Remember to read this:

http://forums12.itrc.hp.com/service/forums/helptips.do?#33

;-)

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: configure DB array as SB array

ok, we'll buy nee modules.