ProLiant Servers (ML,DL,SL)

dl320e gen8 v2 BOOT ERROR

 
lbnbrg
New Member

dl320e gen8 v2 BOOT ERROR

Hi

I have a dl320e gen8 v2. It starts to boot and then the screen goes blank at 30% and code 0114.

Have anyone else experienced the same issue with theses machines.

Regards

1 REPLY 1
Paul_J_K
HPE Pro

Re: dl320e gen8 v2 BOOT ERROR

Hi, 

This is likely to be a component hang or fault as well.  Login to the iLO web administration and check IML logs for any errors or lock ups. based on this necessary troubleshooting or remedial action can be taken. If this is not possible or nothing found there, following might help.

Basic troubleshooting would be to remove all power and perform a power drain. 

Next step is to try one processor and one dimm at a time to check if the processors and dimms are fine. 

Consider the possibility of system board being faulty. 

Other references: 

https://support.hpe.com/hpesc/public/docDisplay?docId=c03257154

https://support.hpe.com/hpesc/public/docDisplay?docId=c03230516

I am an HPE employee
Accept or Kudo