hp6 sata raid in ml310 g2

[ed mcarter]

I am setting up a new ml310 server. I have added a third sata drive and have the hp6_sata_raid controller. my server uses a 4x1 cable. I need to know if there is a kit that contains the cables I need to make the installation. also can you tell me the location where the 12c cable plugs into.

[raadek]

hi,

you need this:
HP 4-port SATA/SAS cable (target fan cable)
389653-B21

rgds.

[raadek]

re 12c cable: are you talking about the I2C cable? if that's the case see attached pic.

[ed mcarter]

Yes thats the one. I see where it plugs into the hp6 board, but can't find the connector where the other end plugs into.

[raadek · Accepted solution]

This is a management link cable.

As there is no management processor onboard of the ML310 G2 you do not need to connect this (hence no port).

[ed mcarter]

Thanks. I take it when I install the target fan cable that the single end connects to port 0 on the board.