HPE Community
ProLiant Servers (ML,DL,SL)
1751750 Members
5272 Online
108781 Solutions
New Discussion

iLO Security Switch Missing on Motherboard

 
morriskr
Occasional Contributor

‎09-20-2010 12:11 PM

‎09-20-2010 12:11 PM

iLO Security Switch Missing on Motherboard

Have two DL380 G6.

Where is system maintenance switch on the motherboard? See battery and NMI jumper next to battery but no maintenance switch next to NMI jumper. Cover says switch should be there and so does manual. Can not configure iLo until switch setting is changed to enable iLo changes. There is literally no switch soldered into the board. Attempting to change setup on boot does not work.
0 Kudos
Reply
1 REPLY 1
morriskr
Occasional Contributor

‎09-20-2010 12:13 PM

‎09-20-2010 12:13 PM

Re: iLO Security Switch Missing on Motherboard

Found it -- see attached picture. Documentation needs adjusting for blinder (older) folks.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.