ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

install trying to use incorrect HAM's

Ayman Altounji
Valued Contributor

install trying to use incorrect HAM's

I bought two ml350's. First one installed without a hitch. Running into a problem on the second one. I installed a Smart Array 431 controller and three 18.2 ultra3 scsi drives - configured as RAID5. Using the SmartStart manual install...then booting off the Novell 5 cdrom. The install defaults to SYMHINW.HAM. If I continue through the install it states that "No storage device was detected in this system, load the appropriate HAM". I tried to manually add CPQARRAY.HAM and CPQSCSI.HAM (which my first ml350 is using) but it states those won't load and deletes them. Any thoughts?

Thanks,
Ken Etter
1 REPLY
Ayman Altounji
Valued Contributor

Re: install trying to use incorrect HAM's

Nevermind.....wish I could blame this on something other than being a little dense at the moment. Problem solved.....just needed to use updated drivers from the latest NSSD.