HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

ml 330 g3

 
augie
Occasional Visitor

ml 330 g3

the server shuts dowm after a few hours. the server will only boot if i clear any data from the memory by pressing the power butting with out the power cable for 5 seconds. then it will run again for couple of hours. can suggestions?? thanks!
6 REPLIES
Gokul Chandola
Trusted Contributor

Re: ml 330 g3

HI,

There may be several problems, so you have to use HP Dignostic tool.

There may several problems like Power supply, motherboard etc.

If you nothing found in HP Dignostics then this is problem with POWER SUPPLY.

Regards,
Gokul Chandola
There is always some scope for improvment.
augie
Occasional Visitor

Re: ml 330 g3

i already replaced the power supply and tried removing all devices before booting and i get the same problem. i also think it might be the motherboard. thank you
Michal Kapalka (mikap)
Honored Contributor

Re: ml 330 g3

hi,

what kind of OS is running on the machine ??

Windows => event log ....

Linux = Sylog / messages ...

mikap
augie
Occasional Visitor

Re: ml 330 g3

win OS is win2003
no error's on the viewer. thanks

Re: ml 330 g3

Hello,

Have you been able to run the HPS tool. Also have you cleared the NVram? Has the server been run in minimal config? Are all FW/Drivers up to date? If you want me to I can have a look at the HPS report for you/provide the tool. Feel free to email me at joakim@hp.com
The difference between ordinary and extraordinary, is that little extra.

Re: ml 330 g3