HPE Community
ProLiant Servers (ML,DL,SL)
1753846 Members
8570 Online
108807 Solutions
New Discussion

pci error

 
Ayman Altounji
Valued Contributor

‎06-04-2001 04:00 PM

‎06-04-2001 04:00 PM

pci error

I had this message "PIC Bus parity error, PIC slot ?" on power up.
had to reset system twice before server started running.
I not sure why there's a question mark is there a problem with a card, or is it the pic bus on-board which is the problem?
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎06-23-2001 04:00 PM

‎06-23-2001 04:00 PM

Re: pci error

This is most likely a card (like an array controller) that has cache memory on the card. Check system configuration utility and see if the is a card that is not recognised properly (it might say PCI-PCI Bridge) or something similar.
Also start removing cards until the issue is resolved, but it should be a card with onboard memory
mark
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.