ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

server ML 150 T G2 : Hot Swap Disk SATA RAID1

 
Mirco Bisigato
Occasional Advisor

server ML 150 T G2 : Hot Swap Disk SATA RAID1

I had a problem with a sever Hp ML 150T G2 with SATA RAID Controller and two disk SATA in coniguration RAID1.One day a disk failed and i replace it (with another same disk) with server power on.The rebulding process do not correct finished and i have called HP support.
and the tecnical support have changed the disk failure.The technician has said to me that this HOT SWAP disks do not have to be change with server power on.Is just true??
7 REPLIES
Mauro Rusignuolo
Trusted Contributor

Re: server ML 150 T G2 : Hot Swap Disk SATA RAID1

Hi,

which controller are you using?

are you talking about:
HP ProLiant ML150 Generation 2 (G2)
brand new?

let me know.

bye.

TJK
<> Leonardo da Vinci
Mirco Bisigato
Occasional Advisor

Re: server ML 150 T G2 : Hot Swap Disk SATA RAID1

This is the controller

Six port SATA Array controller
Mauro Rusignuolo
Trusted Contributor

Re: server ML 150 T G2 : Hot Swap Disk SATA RAID1

HP technicians are righ.
it's not an Hot Swap RAID contoller.

Bye.

TJK
<> Leonardo da Vinci
Mauro Rusignuolo
Trusted Contributor

Re: server ML 150 T G2 : Hot Swap Disk SATA RAID1

Hi,

here is the "Quick Spec" of your system

see the attachment.

bye.

TJK
<> Leonardo da Vinci
Mirco Bisigato
Occasional Advisor

Re: server ML 150 T G2 : Hot Swap Disk SATA RAID1

But.
If I change a failure disk with server poweron
I don't rebuild RAID 1.
Where can I found information about this situation?
The disk mounted is (hot plug) but if i change it, the raid don't recostruction


Mauro Rusignuolo
Trusted Contributor

Re: server ML 150 T G2 : Hot Swap Disk SATA RAID1

may be youo have a "bay" to extract and insert your HDs,
but the controller it's not "hot-swap".
so you if you wanto to change a failed Hd and rebuid the raid one, you have to do the operation "off-line".
with the server switched off.
the rebuild process will start when youo power-on again the system.

other inforation more than the quick spec, I haven't.

bye.

TJK.
<> Leonardo da Vinci
Mirco Bisigato
Occasional Advisor

Re: server ML 150 T G2 : Hot Swap Disk SATA RAID1

Thank you for answer.
I remember this for next installation.
Do you know if there is Certificated HP documentation for this case?