uniprocessor to multiprocessor

[Ayman Altounji]

How do I get NT to recognize the second processor that I just added?

[Ayman Altounji]

follow the instructions in the SSD help file for HAL upgrade. BUT DO NOT REBOOT BEFORE REAPPLYING SERVICE PACK. This is VERY important.

[Ayman Altounji]

Thank you penners for your help .....

[Ayman Altounji]

Install the new processor(s) as noted in the manual for the system itself or that comes with the chips.

Then configure the server hardware to the correct the "APIC Mode" settings. You must start System Configuration and press 'CTRL a' at the first menu after selecting F10 during boot. This activates "Advanced Mode". Then enter System Configuration itself and follow the prompts to complete a basic configuration load. Select to "Review" the settings and then pick "View/Edit Details" from the menu. Look down the list to find "APIC Mode". Press enter on this selection and select "Full Table, Mapped" (or "Full Table" if only choice, depends on specific system). Once this has been done, exit and save changes.

The next step is to load the Multiprocessor HAL on NT. This is best accomplished with the latest Compaq NT SSD (for 3.51 or 4.0 specifically) as this utility will do a more reliable job of identifying the correct HAL for the system. Simply run SETUP.EXE from the SSD disk 1 and select the HAL upgrade (you may also install other drivers if desired, do NOT force all drivers to load as some may not work on your system).