- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- Re: Array stuck in "Interim Recovery" mode
ProLiant Servers - Netservers
1752647
Members
5472
Online
108788
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2005 01:37 AM
02-11-2005 01:37 AM
Array stuck in "Interim Recovery" mode
We had a DL 380 G2 fail and moved one of the mirror drives to an older DL 580. Upon initial boot, we chose to place the boot array in "interim recovery" mode. The server is up and running but we are unable to get the array out of interim recovery mode. Running the array config utility, we are told that we cannot make any changes to the array until the missing drive has been replaced. It is asking for a drive in Port 2 ID 0 of the integrated smart array controller. We are unable to do that. Is there any way to get the array out of interim recovery mode short of deleting the array completely?
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-11-2005 03:36 AM
02-11-2005 03:36 AM
Re: Array stuck in "Interim Recovery" mode
Only three options:
1. Disable Logical Drive
2. Defeat beast and add drive for recovery
3. Backup data and Rebuild array X
1. Disable Logical Drive
2. Defeat beast and add drive for recovery
3. Backup data and Rebuild array X
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP