HPE Community
ProLiant Servers - Netservers
1753809 Members
9242 Online
108805 Solutions
New Discussion

Boot issue with Proliant Microserver GEN10

 
marcelN1
Occasional Visitor

‎04-12-2018 06:33 AM - edited ‎04-12-2018 06:51 AM

‎04-12-2018 06:33 AM - edited ‎04-12-2018 06:51 AM

Boot issue with Proliant Microserver GEN10

Hi there,

I just have my new Proliant Microserver GEN 10 and installed 4 HDD WD Red NAS WD40EFRX. Then i installed Proxmox via the USB. There I selected ZFS RAID10 is file system. It all installed and restarted. After that nothing really happens. It just does not boot from HDD. Ultimatly I get a screen with Shell> . I restarted the system again, and in the BIOS (F11) under boot I see that I cannot select a boot option with HDD. Only have the following options:

  • UEFI: IPv4 P1 HP Ethernet 1Gb 2-port 332i Adapter - NIC
  • UEFI: IPv4 P2 HP Ethernet 1Gb 2-port 332i Adapter - NIC
  • UEFI: IPv6 P1 HP Ethernet 1Gb 2-port 332i Adapter - NIC
  • UEFI: IPv6 P2 HP Ethernet 1Gb 2-port 332i Adapter - NIC
  • UEFI: Built-in EFI Shell
  • Disabled

In the BIOS I do see under SATA configuration for PORT 1-4 an entry with WDC WD40EFRX-6. So how come that it does not boot via the HDD?

Marcel

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.