Bootup will not complete without user intervention

[Jeff Russell_1]

I have a proliant PL1600R with two SCSI 4.3GB drives. During the bootup process, I get to the following place:

<<< Press for SCSISelect Utility! >>>

and then, the drives are found properly, but I get the next messages:

Press "F1" key to continue
"F10" key for System Partition Utilities

If I press F1, system bootup continues successfully, but if I press F10, it says that the system partition utilities do not exist. I don't care so much about the system partition utilities, but I want to know how to bypass ...

[CA859951]

Jeff:

Here is a document to assist you in the disable of the F1 prompt:
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00182008&prodTypeId=15351&prodSeriesId=397634&locale=en_US

G'luck! -john

[Gio_4]

I have a similar problem, but when I load the Configuration Utilities at boot time, I don't get any option for disabling F1.
When Config starts I am already in Advanced Features.
(Details: DL380 P17 (Bios 18/12/2002), which is the latest version I have found).
Any help will be appreciated.
Thanks.
Gio

[Jeff Russell_1]

I had the same lack of success as the last post. I just never got around to re-posting on it. At any rate, I am still stuck with having to press F1 to continue at each bootup.