Community
ProLiant Servers - Netservers
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Re: Cannot Procede to install OS in Smart Start after array config

 
TIMOTHY CARLISLE
New Member

‎08-26-2008 01:21 PM

‎08-26-2008 01:21 PM

Cannot Procede to install OS in Smart Start after array config

I am trying to use the Smart Start utility to configure the arrays and load the OS on a new DL320s server. I have configured the arrays but when I proceed to "Deploy" the OS, and click continue, nothing happens. Boot controllr disk size is showinf -1 mb in the Server Deployment Hardware Configuraton after configuring the arrays. Is there a wait time after array and logical drive configuration or have I missed a step?
0 Kudos
Reply
2 REPLIES 2
Prem Selvam Arumugam
Trusted Contributor

‎09-01-2008 08:50 AM

‎09-01-2008 08:50 AM

Re: Cannot Procede to install OS in Smart Start after array config

Timothy

Did you tried to configure the array by pressing ctrl+S while booting

Please check may be some times Array controller error
0 Kudos
Reply
TIMOTHY CARLISLE
New Member

‎09-16-2008 07:03 AM

‎09-16-2008 07:03 AM

Re: Cannot Procede to install OS in Smart Start after array config

I just went to plan B, load the OS, which I did not want to do. Now I have to load the drivers from Windows. All went well withthat except for the network adapter configuration whaic I am working on now.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.