DL360 G4P SATA - No video

[Woocheol Lee]

I tried to turn on my backup server which has not been used for 6 months. When I turn it on, it doesn't give me video, and provide big fan noisy. What the things I should check first? I replaced the memories, but got same result. Is there anyway to reset it as a factory default? Thanks....

[James ~ Happy Dude]

Hello Woocheol,
IS there any Red LEDs on the server/system board ?? Do you have additional PCI cards installed?

Try removing the Additional cards; try booting with minimum configurations;

Regards,
James.

[Woocheol Lee]

Thanks for comment.

The led is green, and I didn't put additional PCI card. I add only harddisk and cdrom from basic configuration.

[James ~ Happy Dude]

Hello,

Try clearing the NVRAM, using the system maintenance switch SW6;

Regards,
James.

[RaMpaNTe]

Try reseating the Processor and make sure the memory is populated correctly. Bring the server to its minimal config. Swap memory dimms and processors in case you had 2. And clear NVRAM then start adding parts one by one.

[Woocheol Lee]

When I turn on server without any modification yesterday, it shows video JUST ONE TIME. However same situation after that. I reset NVRAM using SW6, and reseat CPU, but same result. Any idea on this?
Thanks again...