ProLiant Servers - Netservers

DL360 G4P SATA - No video

 
Woocheol Lee
New Member

DL360 G4P SATA - No video

I tried to turn on my backup server which has not been used for 6 months. When I turn it on, it doesn't give me video, and provide big fan noisy. What the things I should check first? I replaced the memories, but got same result. Is there anyway to reset it as a factory default? Thanks....
5 REPLIES 5
James ~ Happy Dude
Honored Contributor

Re: DL360 G4P SATA - No video

Hello Woocheol,
IS there any Red LEDs on the server/system board ?? Do you have additional PCI cards installed?

Try removing the Additional cards; try booting with minimum configurations;

Regards,
James.
Woocheol Lee
New Member

Re: DL360 G4P SATA - No video

Thanks for comment.

The led is green, and I didn't put additional PCI card. I add only harddisk and cdrom from basic configuration.
James ~ Happy Dude
Honored Contributor

Re: DL360 G4P SATA - No video

Hello,

Try clearing the NVRAM, using the system maintenance switch SW6;

Regards,
James.
RaMpaNTe
Trusted Contributor

Re: DL360 G4P SATA - No video

Try reseating the Processor and make sure the memory is populated correctly. Bring the server to its minimal config. Swap memory dimms and processors in case you had 2. And clear NVRAM then start adding parts one by one.
You heve a question... I have an aswer!!!
Woocheol Lee
New Member

Re: DL360 G4P SATA - No video

When I turn on server without any modification yesterday, it shows video JUST ONE TIME. However same situation after that. I reset NVRAM using SW6, and reseat CPU, but same result. Any idea on this?
Thanks again...