ProLiant Servers - Netservers

[DL360 Series] Can't access RBSU

 
SOLVED
Go to solution
Emiel Molenaar
New Member

[DL360 Series] Can't access RBSU

On my DL360 (Dual P3 1.13), i am unable to access the RBSU or BIOS. I've read the manual wich tells me to press F9 during system power up. This does not work. Any suggestions? Thanks in advance!
2 REPLIES 2
BR894765
Valued Contributor
Solution

Re: [DL360 Series] Can't access RBSU

As I remember, first generation of DL380 did not have RBSU.
It uses special system partition, accessed by F10 right after POST.
Often this partition is deleted by mistake. You can configure server from SmartStart 5.5 (or config diskette).

If you reinstall server from scratch, you can reinstall system partition from SmartStart.
Emiel Molenaar
New Member

Re: [DL360 Series] Can't access RBSU

Thanks for the reply.

Very weird, the manual says it does contain a RBSU.

The reason I have to access the RBSU is to change the boot order (I want to boot the server from LAN). I'll give it a go with SmartStart 5.5.