ProLiant Servers - Netservers

DL360G4 and Smart Array 642

 
CA1234206
Occasional Contributor

DL360G4 and Smart Array 642

Hi

Is it possible to have a 642 controller as the boot controller?

I have installed the 642 controller and adjusted the RBSU to have the 642 controller as the boot controller, but only the internal 6i controller can see the 2 internal disks.

I recall on other systems I'd have to physically recable the disks to the new controller.

I can see the internal SCSI connector on the 642 controller, but can't see where on the main board I need to disconnect the 6i and connect the 642

any help appreciated
Simon
2 REPLIES 2
Oleg Koroz
Honored Contributor

Re: DL360G4 and Smart Array 642

SCSI cable should be connected from 642 to top right connector if you standing from front. Smaller short cable from system Board should be pulled. For more access pull fan assembly out.
What make Difference for you 642 it's same as 6i if you add BBWC.
CA1234206
Occasional Contributor

Re: DL360G4 and Smart Array 642

yes i've realised that i don't need the 642 controllers in the G4 servers.

thanks for your help