- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- HP DL385 - PXE Install Centos 5.2
ProLiant Servers - Netservers
1753856
Members
7279
Online
108809
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-13-2009 06:50 AM
10-13-2009 06:50 AM
HP DL385 - PXE Install Centos 5.2
Hi.
I am PXE booting a DL385 and performing a newwork install of CentOS 5.2 via http. THe server boots into the installer fine, receiving an IP and loading the CentOS installation as predicted.
Once i've run through the regional settings of the installer it is unable to fine any disks to format and install linux. Any ideas? Or do i need specific drivers to load during boot? If so can someone point in the right direction to create a floppy / usb to load them.
Thanks.
I am PXE booting a DL385 and performing a newwork install of CentOS 5.2 via http. THe server boots into the installer fine, receiving an IP and loading the CentOS installation as predicted.
Once i've run through the regional settings of the installer it is unable to fine any disks to format and install linux. Any ideas? Or do i need specific drivers to load during boot? If so can someone point in the right direction to create a floppy / usb to load them.
Thanks.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP