ProLiant Servers - Netservers

HP MICROSERVER GEN10

 
Bulldozer
Occasional Contributor

HP MICROSERVER GEN10

Hi,

I need some advise please, Ive tried to swap a disk im my microserver so powered it down, swapped the disks and restarted it, but the current OS ( Win Server 2016 ) wont load since than, checked bios options and strangely non of my sata drives shown in UEFI mode, when I go to boot options I only see the ethernet ports and the built in console as an option and no hard drives. If I switch to legacy mode I can see my drives but system still wont load up because my os disk is UEFI. 

Also dont understand that in BIOS sata configuration all drives greyed out, why? Any ideas please?

1 REPLY 1
Paul_J_K
HPE Pro

Re: HP MICROSERVER GEN10

Please try to check in BIOS whether the drives were previously configured in RAID or other in the Marvell utility if this is the controller used.

Refer: https://support.hpe.com/hpesc/public/docDisplay?docId=c05355808

Page 69 onwards.

 
 
I am an HPE employee
Accept or Kudo